The device featured in the image below contains the same pressurization properties of a standard gun but with the emission of a powerful blast like a fire hose rather than weaker and shorter bursts. The commercially available Super Soaker fun toys are similar to the appearance of this water blaster. The only difference is that pressurized air is meant to be used by this design to gain greater power and accuracy when shooting water over a long distance.

An onboard water reservoir, a trigger system, and a spherical rubber bladder contained in the gun are all in a black finish. A pump bladder system is used to pressurize the water in the reservoir and with the press on the trigger like a standard water gun, the nozzle releases the compressed water. Depending on the nozzles used, the ranges of fire vary with the maximum distance of about 50 feet.

The image below shows the parts that can be detached from the current design. A 3” PVC end cap surrounded by a 1” long part cut out of a 3” ABS coupler is the magic between the reservoir and the pressure chamber. The PVC end cap fits perfectly within the ABS coupler piece and the coupler piece fits perfectly within the 4” drain pipe as well. The reservoir can get separated from the PC by having to epoxy/cement everything inside.

Different types of nozzles can be used on this water blaster and they can be seen in the images below:

This nozzle laminator has end cap drilled to 7/32” that can reach a maximum range of 41ft. The shot time is 4 sec and the output is 350mL/sec.

This nozzle laminator has end cap drilled to 3/8” with a maximum range of 50ft. the shot time is 2 sec and the output is 850mL/sec.

This is the riot blast that has the most kickback. It can reach a maximum range of 45ft with shot time of 1 sec and output of 1200mL/sec.